[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [linrad] Analog hardware tune

To: <linrad@xxxxxxxxxxxxxxxxxxxxxx>
Subject: Re: [linrad] Analog hardware tune
From: "Niels Montanana" <nielsm@xxxxxxxxxxxxx>
Date: Sun, 28 Nov 2004 16:24:48 -0000
References: <001401c4d549$6f19b0a0$2dc5e150@computer>
Reply-to: linrad@xxxxxxxxxxxxxxxxxxxxxx
Sender: owner-linrad@xxxxxxxxxxxxxxxxxxxxxx

OK - I found out what I had to do.

I needed to set the sampling rate of the Delta-44 using the command

ossmix -d1 envy24.rate 96000

Niels, G8RWG

----- Original Message -----

From: Niels Montanana

To: linrad@xxxxxxxxxxxxxxxxxxxxx

Sent: Sunday, November 28, 2004 12:46 PM

Subject: [linrad] Analog hardware tune

Leif

I have connected up the WSE modules and they all seem to work fine. I have been trying to use the ANALOG HARDWARE TUNE mode but I keep on getting a message "Set Two RX channels I/Q data, 96kHz and 32 bit". I have a Delta44 soundcard and I am using /dev/dsp4 which is configured as 48kHz, 4 channels and 32 bit. For the radio interface I am using option 4, Two rx channels, I/Q.

Have I missed something out in my Delta-44 configuration ?

73

Niels, G8RWG

LINRADDARNIL

References:
- [linrad] Analog hardware tune
  - From: Niels Montanana

Prev by Date: [linrad] Analog hardware tune
Next by Date: [linrad] Calibrating the WSE modules
Previous by thread: [linrad] Analog hardware tune
Next by thread: [linrad] Calibrating the WSE modules
Index(es):
- Date
- Thread