I tried exiting and reentering the program. The results are the same. I have no control of WSE hardware.
-----Original Message-----
From: Leif Asbrink <leif@xxxxxxxxxx>
To: linrad@xxxxxxxxxxxxxxxxxxxx
Sent: Thu, 17 Jan 2008 8:09 pm
Subject: Re: Linrad 02-41
Hi Again Stan,
Maybe, if you start Linrad and run through the
general parameters setup (screen, parport etc.) you
would have to exit and restart Linrad to make your
choices valid. Please try that and tell me if it works.
Maybe I have to force an exit after running 'S'=Global.....
73
Leif / SM5BSZ
> I was unable to get 02-41 working with my WSE hardware. It uses
> Parport 888 and Ack=10
> I try to do Z=Hardware Test and the Linrad program shuts down.
>
> This same computer works fine with Linrad 02-35
>
> Stan, KA1ZE/3
> >