[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Linrad] WSE / Delta44 / Linad / MAP65 Windows local host setup
- Subject: [Linrad] WSE / Delta44 / Linad / MAP65 Windows local host setup
- From: wi7p <emeshack.com; wi7p@xxxxxxxxxxxxxxxx>
- Date: Sun, 26 Oct 2008 15:10:37 -0700 (PDT)
Does WSE/Linad/MAP65 need to swap I&Q when using M-Audio's cable?
I am trying to get that combination running Windows XP Home edition
Pack 3 on the same computer. I am using the Weak Signal Equipment for
end with a M-Audio Delta-44 card. I am using the audio cable that came
I think I am close. You can check out a screen dump at:
I was sending "CQ WI7P DN40" on another computer into a FT726 with
I can see/hear the tones on Linrad and see them on MAP65 but it is not
One clue might be that to get Winrad to receive a USB signal I had to
set it to
LSB or select "Swap I and Q channels" under ShowOptions.
Is there a selection that I have missed in Linrad to do the same
I have placed copies of my Linrad Config files at:
I also listened for signals off of the moon this morning but only had
I hope I can find someone in the USA with the same hardware who is
willing to help me.
A note for Leif. It took me a while to find out which control set the
I missed that in the documents I have been
The versions I am running are:
Winrad V 1.32 Build 020 // WSEControl
Linrad-02.47 Made modifications given by Alex HB9DRI to have it work
a local host. Thanks all!
MAP65 Version 0.9 r1026
M-audio driver Version 5.10.00.0036 Panel Version: 1.03.16-2.1.04
Thanks for any help!
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en