[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [linrad] Re: AC97 and Linrad; works at W3SZ using OSS



audio out on pcm port. speaker does not work
arie

----- Original Message -----
From: Rein A. Smit <rein0zn@xxxxxxxxxxxxx>
To: <w3sz@xxxxxxxxxxx>; <linrad@xxxxxxxxxxxxxxxxxxxxxx>
Sent: Saturday, April 12, 2003 1:09 PM
Subject: [linrad] Re: AC97 and Linrad; works at W3SZ using OSS


>
>   Hello Roger,
>
>   Thanks for reply. I am using the the VIA VT82Cxx driver, it comes with
>   Mandrake.
>   I thought to read into you old DSP page ( 2001 or so ) that you
>   had Linrad running with (1) one card and without OSS. Is that
>   true? I also read in Leif's early notes that he used only
>   one card at the time?
>   Perhaps I am trying to do something that is not possible or
>   has not be done before with Linrad?
>   The AC97 is working OK for playing CD's etc. The problem is to
>   get the DSP processed output from Linrad to get to the
>   AC97 and to disconnect the speaker output from the front end
>   module ( the digitizing  part ) I believe that is because I
>   have no good control how to set-up the AC97 ( mixer problem )
>
>   It is in the instructions where Lief writes to use the mixer
>   ot set-up the audio cared where things are failing ( I think )
>
>   I wished somebody could tell me that this is nonsense or that
>   it is making sense...
>
>   I also would like to know the signal flow into the audio card(2)
>
>   RX audio into "line"?
>   Digitized signal out from card into bus...
>   Linrad DSP processed signal via bus into audio card ...
>   audio signal out on "speaker" or "PCM" ....
>
>   73 Rein
>
>
> w3sz wrote:
> >
> > Hi, Rein!
> >
> > WIth my latest computer brought online I am using the onboard audio
> > which I believe is the same as the AC 97 you refer to, and things work
> > fine with svgalib and linrad.
> >
> > This machine is a homebrew P3 using a SOYO motherboard @ 1.0 GHz, RHL
> > 8.0, Delta44 input and motherboard VIA97 audio output.  The audio didn't
> > work with svgalib and the RHL audio drivers, so I use the OSS drivers.
> >
> > The OSS driver for the onboard sound is 'VIA VT82C686 AC97 audio'.  I
> > had to pay an extra $15 for it. After my web purchase of the addon, they
> > just emailed me a new license file.
> >
> > OSS and run Linrad without identified problems.
> >
> > I don't know if this information will be of help to you or not, but I
> > hope it is of some help.
> >
> > 73,
> >
> > Roger
> > W3SZ
> > --
> > Please note that there may be an antispam preamble to the "replyto"
> > address.  IF so, remove it to reply directly to this message.  Thank
you!
> >
> > Roger Rehr
> > W3SZ
> > 2 Merrymount Road
> > Reading, PA 19609
> > http://www.qsl.net/w3sz
>

LINRADDARNIL