Re: [linrad] Re: AC97 Sound card issues.

[Kohjin Yamada <kohjin@xxxxxxxxxxxxxxx>]

Hi Rein,

At 15:46 03/05/10 -0700, you wrote:
>     Question: do you have in your alsamixer a slider marked "HEAD"
>     and do you get any reaction from the jumpers at the bottom of
>     the sliders. I do not! It does not make any difference whether
>     they are open or closed.

No there's no slider marked "HEAD" for both SB PCI128 and Delta 44.
I'm sure it depends on the sound card.
What I did was to set level 81 for "Master" and "PCM" slider.
(Also set the level of ADC etc for Delta 44, not an issue)

>
>     73 Rein

Kohjin - JR1EDE

>Kohjin Yamada wrote:
>> 
>> Hello Arie and ALL,
>> 
>> Been reviewing archived emails ever exchanged between Arie and Rein
>> regarding via82xx sound card and ALSA I think I would input (again) for
>> svgalib-1.9.17.
>> 
>> Leif describes how to install version 1.4.3 in his webpage but doesn't write
>> about this newer version of svgalib.
>> We had ever discussed these in thread "Console Swicthing problem" or like
>> around past January this year.
>> (I have posted my solution with the same subject at 19 Jan 2003)
>> 
>> Arie, your problem of console switching will easily be solved by 
>svgalib-1.9.17.
>> You can download it from:
>> You can get the source from http://www.arava.co.il/matan/svgalib/ .
>> Installation is not difficult.
>> 
>> At 23:14 03/04/12 +0200, Arie PA0EZ wrote:
>> [snip snip snip]
>> 
>> >If I run linrad directly on the console ( not a terminal in X) than I can
>> >switch between linrad and the mixer controls on X without "loosing"linrad.
>> >Again pressing ctrlalt-f2 brings me back in the running linrad. Pity that
>> >linrad stops working once you are in X. That makes setting up the mixer
>> >controls rather messy.
>> 
>> [snip snip snip]
>> 
>> >73
>> >Arie
>> 
>> Kohjin - JR1EDE


LINRADDARNIL