[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [linrad] suggestions as to next step ??



Hello Tom,

Try `modprobe svgalib_helper`.

Kohjin - JR1EDE

PS: Gee...I wanted to make it sure for you but something happened on my
Debian. I can't compile svgalib-1.9.17, why???!!!
I think I better go for bed tonight, too tired. See you tomorrow.

At 08:35 03/04/14 -0600, you wrote:
>        Hello -- I have a fresh install of Redhat
>8, the libraries (nasm etc.) are in, svgalib-1.9.17 and finally linrad all
>in as per instructions I am fairly certain ( although I am certainly very
>new to Linux !).
>
>When I type ./linrad I get the message "cannot open  /dev/svga".
>
>    I am at a loss as to where to go from this point and any suggestions
>would be most helpfull.
>
>If it helps, I am running a biostar M7VKB motherboard with a kt133 chipset
>and ac97 on board sound w/ 1300 Mhz  AMD Duron.
>
>Thanks very much --
>Thomas Collins - N0QAZ
>Greeley CO USA
>tcollins88@xxxxxxxxx

LINRADDARNIL
a