[linrad] Re: Xpol yagi options

["Jurgen van de Glind" <pe1lwt@xxxxxxxxx>]

Hi Conrad,

Yes I do have dual relay (cx800n) in FRONT of the polarity relays. From this
relay I have 2 coaxline running down  RX side to preamp>lineamp>linrad. TX
side to polarity relays.

GL 

Jurgen PE1LWT

> -----Oorspronkelijk bericht-----
> Van: Linrad mailinglist [mailto:linrad@xxxxxxxxxxxxxxxxxxxxx] Namens
> Conrad_G0RUZ
> Verzonden: donderdag 24 november 2005 2:34
> Aan: Linrad mailinglist
> Onderwerp: [linrad] Xpol yagi options
> 
> I have read the xpol suggestions on
> http://www.nitehawk.com/sm5bsz/polarity/simplesw.htm and I hope to use my
> new antennas in an X formation. The highpower 3 relay solution looks best
> but I suppose that I will have to use an additional 2 relays at each
> orthogonal pair to separate out the independent RX paths needed for the 2
> channel Linrad hardware.
> 
> Who is actually doing this at the moment, I think maybe PE1LWT?
> 
> 73
> 
> Conrad G0RUZ
> 
> 
> 
> #############################################################
> This message is sent to you because you are subscribed to
>   the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
> To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
> To switch to the DIGEST mode, E-mail to <linrad-
> digest@xxxxxxxxxxxxxxxxxxxxx>
> To switch to the INDEX mode, E-mail to <linrad-
> index@xxxxxxxxxxxxxxxxxxxxx>
> Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>



#############################################################
This message is sent to you because you are subscribed to
  the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>


LINRADDARNIL