[linrad] Re: Linrad-02.04

[Ramiro Aceves <gmail.com; ea1abz@xxxxxxxxxxxxxxxx>]

Leif Asbrink wrote:
> Hi Ramiro,
>
>
> > I have just downloaded Linrad-02.05 and I can go a little bit further 
> > but It crashes again. This is the sequence of commands
> >
> >
> > I press "S"
> > I choose "1" font size.
> > I choose "N" to allow swapping.
> >
> > I press "A"  for weak signal CW
> > I choose device 63     /dev/dsp
> > I choose RDRW   "W"
> > I choose "one RX channel"
> > I choose 44100 sampling rate
> > "close and reopen"? ----> "YES"
> > I press a key to return to the main menu.
> > I press "w" to save setup
> > I press "A" for weak signal CW.
> > I enter into the parameter selection screen
> > I press "Enter"
> > I press "Enter"
> > I press "Enter"
> > I press "Enter"
> >
> > It bombs out:
> > "segmentation fault"
>
> Could be CPU overload. Try to deselect fft2 and also
> set baseband storage time low. Remove par_wcw first
> because otherwise you may not be able to reach the
> parameter setting screens. (or edit par_wcw manually)

Hello Leif, I have done the changes that you suggested with no luck. The 
program crashes at the same function.

Program received signal SIGSEGV, Segmentation fault.
[Switching to Thread 1132374960 (LWP 6457)]
0x080a7bb1 in rx_output ()

I have disabled second fft and reduced baseband storage to 1 second. I 
am running a 1 GB RAM, 1.86 GHz Pentium Centrino laptop.

If you need more tests please let me know.

Ramiro.
EA1ABZ.



#############################################################
This message is sent to you because you are subscribed to
 the mailing list <linrad@xxxxxxxxxxxxxxxxxxxxx>.
To unsubscribe, E-mail to: <linrad-off@xxxxxxxxxxxxxxxxxxxxx>
To switch to the DIGEST mode, E-mail to <linrad-digest@xxxxxxxxxxxxxxxxxxxxx>
To switch to the INDEX mode, E-mail to <linrad-index@xxxxxxxxxxxxxxxxxxxxx>
Send administrative queries to  <linrad-request@xxxxxxxxxxxxxxxxxxxxx>


LINRADDARNIL